Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Last revisionBoth sides next revision | ||
equipment:gweike_1390n_130_watt_laser_cutter [2021/02/08 20:38] – admin | equipment:gweike_1390n_130_watt_laser_cutter [2023/03/23 16:19] – [Set the focus] admin | ||
---|---|---|---|
Line 31: | Line 31: | ||
==== Set the focus ==== | ==== Set the focus ==== | ||
- | - Now, go to the cutter. Put in your material that you want to cut/engrave. | + | - For focusing, please refer to the youtube link here: https:// |
- | - Navigate the laser head to the center of your work, and put the focus block underneath the PROBE, not the red dot. | + | - Or, go to youtube |
- | - On the RUIDA control panel, press Z/U button in the middle of the arrows. | + | - Watch vid and do what the fat guy instructed |
- | - Here you can hit left or right arrows | + | |
- | - Press the down arrow until you get to Autofocus. | + | |
- | - MAKE SURE THAT THE WOOD BLOCK IS UNDER THE PROBE. | + | |
- | - Press enter. The machine will set the proper focal length. | + | |
- | - REMOVE the focus block. | + | |
- | - The machine is now focused properly. | + | |
==== Prepare and send your file ==== | ==== Prepare and send your file ==== |