Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
equipment:gweike_1390n_130_watt_laser_cutter [2020/12/02 19:04] – admin | equipment:gweike_1390n_130_watt_laser_cutter [2021/02/08 20:38] – admin | ||
---|---|---|---|
Line 24: | Line 24: | ||
===== Basic Use of Machine ===== | ===== Basic Use of Machine ===== | ||
- | The following steps should get you started. You are encouraged to find tutorials | + | |
- | {{ : | + | ==== Turn on the machine ==== |
- | - Take your svg to the computer designated for that cutter. You must be logged into the Guest Laser account. | + | - Open the lid. |
- | - Open Lightburn application. If it asks for registration information, you're in the wrong account. | + | - Turn the machine on by turning |
- | - Open your SVG file in Lightburn. | + | - The machine will auto-home, then will return |
- | - Find the connection | + | |
- | - For each of your colors of your file, adjust power settings and sequencing in the Cuts/Layers dialog in Lightburn. | + | ==== Set the focus ==== |
- | | + | |
- Now, go to the cutter. | - Now, go to the cutter. | ||
- Navigate the laser head to the center of your work, and put the focus block underneath the PROBE, not the red dot. | - Navigate the laser head to the center of your work, and put the focus block underneath the PROBE, not the red dot. | ||
Line 40: | Line 39: | ||
- Press enter. The machine will set the proper focal length. | - Press enter. The machine will set the proper focal length. | ||
- REMOVE the focus block. | - REMOVE the focus block. | ||
+ | - The machine is now focused properly. | ||
+ | |||
+ | ==== Prepare and send your file ==== | ||
+ | - Take your svg to the computer designated for that cutter. You must be logged into the Guest Laser account. | ||
+ | - Open Lightburn application. | ||
+ | - Take your svg to the computer designated for that cutter. You must be logged into the Guest Laser account. | ||
+ | - Open Lightburn application. | ||
+ | - Open your SVG file in Lightburn. | ||
+ | - Find the connection "Fat Bastard" | ||
+ | - For each of your colors of your file, adjust power settings and sequencing in the Cuts/Layers dialog in Lightburn. | ||
+ | - Once you have your settings they way you want them, select " | ||
+ | |||
+ | ==== Load the File on the Laser Buffer==== | ||
- Press File button. | - Press File button. | ||
- Confirm your layer cut settings (speed/ | - Confirm your layer cut settings (speed/ | ||
- | | + | |
+ | ==== Set our Origin and test your perimeter ==== | ||
+ | |||
+ | | ||
- Press Origin button. | - Press Origin button. | ||
- Press Frame button to verify the perimeter of your work. | - Press Frame button to verify the perimeter of your work. | ||
+ | |||
+ | ==== Last step: Cut/ | ||
- MAKE SURE COOLER, AIR ASSIST and BLOWER are all on. | - MAKE SURE COOLER, AIR ASSIST and BLOWER are all on. | ||
- If happy with everything, press Start button on control panel to begin cutting. | - If happy with everything, press Start button on control panel to begin cutting. | ||
+ | |||
+ | |||
+ | |||
+ | {{ : | ||
+ | |||
=== Design === | === Design === | ||