Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Next revision		Previous revision
equipment:delta_drill_press [2020/09/03 16:50] – created leamonequipment:delta_drill_press [2020/09/08 20:50] (current) – [Details] leamon
Line 1: Line 1:
-====== Craftsman 14" band saws ======+====== Delta drill press ======
  
 {{:equipment:20200901_183753.jpg?direct&400|}} {{:equipment:20200901_183753.jpg?direct&400|}}
  
-The manual can be found [[https://www.searspartsdirect.com/manual/bmfi8a9zp4-000247/craftsman-113243311-band-saw|here]]+Good for drilling holes in wood. 
 + 
 +The manual can be found [[https://images.homedepot-static.com/catalog/pdfImages/22/228b61e7-80cd-446a-9d94-2ba0347ec51c.pdf|here]]
  
 ===== Safety ===== ===== Safety =====
  
   * Safety glasses are **always** required.   * Safety glasses are **always** required.
-  * Hearing protection and dust masks are highly recommended +  * Make sure the drill is turned off and unplugged before working on the saw itself
-  * Keep the blade guard down as far as possible, to leave only the necessary amount of the blade exposed for the work you're doing.  This can be adjusted by easing off the adjustment screw on the right hand side and using the wheel at the back to adjust the guard up or down.  Be sure to right tighten the adjustment screw afterward. +
-  * Make sure the saw is turned off and unplugged before working on the saw itself+
  
 ===== Special Instructions ===== ===== Special Instructions =====
  
-  * Start the saw. +  * Mark where you want to make your hole and line the drill bit up with your mark. 
-  * Feed your work into the saw in a controlled fashion, not too quickly. +  * Secure the wood piece to the table with a firm grip or with clamps if necessary. 
-      * If you find burn marks on your wood, you need to move the wood through the saw a bit more quickly, or reduce the saw speed. +  * Start the drill. 
-  * Make sure the saw comes to a complete stop before walking away from it. +  * Slowly pull down the level to drill into the wood.
  
 ===== Details ===== ===== Details =====
Line 32: Line 31:
 |- |-
 |Model |Model
-|113.243310 and 113.243311+|17-950L
 |- |-
-|Maximum cutting depth +|Table size 
-|12 inches+|18" x 14"
 |- |-
-|Maximum cutting height +|Speed 
-|Approximately 6 inches+|250-3000 RPM in 12 steps
 |- |-
-|Blade size +|Chuck 
-|80 inches+|5/8" (keyed) 
 +|- 
 +|Motor horse power 
 +|1/2 HP
 |- |-
 |Power |Power
 |120 Volt |120 Volt
 |- |-
-|Owners +|Owner 
-|Dave Alverson, Dennis Martin +|[[profiles:jeffjohnson|Jeff Johnson]]
-|- +
-|Who to call? +
-|?+
 |- |-
 |} |}