Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
dust_collectors [2017/08/07 03:11] – [Instructions] Jeff Johnsondust_collectors [2023/02/21 00:21] (current) – Added _update tag, as information needs to be updated bradley_madaris
Line 1: Line 1:
 ====== Dust Collector ====== ====== Dust Collector ======
 +
 +//_update//
 +
 {{ :20170707_152651_4_.jpg?150|}}Our dust collector is designed to capture the majority of the dust our larger sawdust making machines. It uses a Harbor Freight system that has been modified to incorporate Oneida Systems Super Dust Deputy cyclone to capture most of the debris, and a Wynn Environmental MERV 15 air filter to keep the fine particulates down. {{ :20170707_152651_4_.jpg?150|}}Our dust collector is designed to capture the majority of the dust our larger sawdust making machines. It uses a Harbor Freight system that has been modified to incorporate Oneida Systems Super Dust Deputy cyclone to capture most of the debris, and a Wynn Environmental MERV 15 air filter to keep the fine particulates down.
  
 ===== Instructions ===== ===== Instructions =====
 {{:dustcollectorswitch.jpg?200 |}} There is an on switch next to the motor on the wall. Flipping it to the on position will turn on the collection system. To make sure it is working at full functionality, close all unneeded gates and open it for the equipment you plan on using. See the specific collection instructions for the equipment we have connected (listed below). {{:dustcollectorswitch.jpg?200 |}} There is an on switch next to the motor on the wall. Flipping it to the on position will turn on the collection system. To make sure it is working at full functionality, close all unneeded gates and open it for the equipment you plan on using. See the specific collection instructions for the equipment we have connected (listed below).
-{{:dustcollectorswitch.jpg?200 |}}+
 ==== Table Saw ==== ==== Table Saw ====
 The 4 inch hose on floor on the right side needs to be connected to the 4 inch port that is on the corner. When not in use, close this port by putting the cap on the port. The 4 inch hose on floor on the right side needs to be connected to the 4 inch port that is on the corner. When not in use, close this port by putting the cap on the port.