Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Next revision		Previous revision
dust_collectors [2017/08/07 03:00] – created Jeff Johnsondust_collectors [2023/02/21 00:21] (current) – Added _update tag, as information needs to be updated bradley_madaris
Line 1: Line 1:
 ====== Dust Collector ====== ====== Dust Collector ======
-Our dust collector is designed to capture the majority of the dust our larger sawdust making machines. It uses a Harbor Freight system that has been modified to incorporate Oneida Systems Super Dust Deputy cyclone to capture most of the debris, and a Wynn Environmental MERV 15 air filter to keep the fine particulates down.+ 
 +//_update// 
 + 
 +{{ :20170707_152651_4_.jpg?150|}}Our dust collector is designed to capture the majority of the dust our larger sawdust making machines. It uses a Harbor Freight system that has been modified to incorporate Oneida Systems Super Dust Deputy cyclone to capture most of the debris, and a Wynn Environmental MERV 15 air filter to keep the fine particulates down.
  
 ===== Instructions ===== ===== Instructions =====
-There is an on switch next to the motor on the wall. Flipping it to the on position will turn on the collection system. To make sure it is working at full functionality, close all unneeded gates and open it for the equipment you plan on using. See the specific collection instructions for the equipment we have connected (listed below).+{{:dustcollectorswitch.jpg?200 |}} There is an on switch next to the motor on the wall. Flipping it to the on position will turn on the collection system. To make sure it is working at full functionality, close all unneeded gates and open it for the equipment you plan on using. See the specific collection instructions for the equipment we have connected (listed below).
  
 ==== Table Saw ==== ==== Table Saw ====
Line 9: Line 12:
  
 ==== Chop Saw ====  ==== Chop Saw ==== 
-{{:chopsaw_dust2.png?400|}}The compound miter saw is piped to two locations underneath. The bottom gate should be open, and the the port directly under the saw has a separate gate. This can be optionally open or closed depending if you want to use the hose independently for general cleanup.+{{:chopsaw_dust2.png?200 |}}The compound miter saw is piped to two locations underneath. The bottom gate (blue box in picture) should be open, and the the port directly under the saw has a separate gate (the yellow box in picture). This can be optionally open or closed depending if you want to use the hose independently for general cleanup.