Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
24_inch_vinyl_cutter [2018/04/04 13:21] – Jeff Johnson24_inch_vinyl_cutter [2022/03/16 18:56] (current) – Jeff Johnson
Line 47: Line 47:
 Make sure that the blade can turn freely (by attempting to turn it with your Make sure that the blade can turn freely (by attempting to turn it with your
 fingers while the release button of the Blade Carriage is pressed). fingers while the release button of the Blade Carriage is pressed).
-Adjust the blade depth of the Blade Carriage [[24_inch_vinyl_cutter|(See here)]] and Force setting on the +Adjust the blade depth of the Blade Carriage (See Blade Setup below) and Force setting on the 
-cutter (page 8) until you are getting solid, uniform cuts. Start with a blade depth+cutter ([[https://www.uscutter.com/static/PDFs/SC_Manual_06_27_2016.pdf|manual]], page 8) until you are getting solid, uniform cuts. Start with a blade depth
 of around 1/64th of an inch and a pressure setting of 100g and try an increased of around 1/64th of an inch and a pressure setting of 100g and try an increased
 pressure setting before attempting to increase the blade depth. pressure setting before attempting to increase the blade depth.
Line 100: Line 100:
 where the left and right arrows of the control pad adjust where the left and right arrows of the control pad adjust
 the position of the carriage and the up and down arrows the position of the carriage and the up and down arrows
-advance and retreate the media via the feed rollers. Once+advance and recreate the media via the feed rollers. Once
 you have your media and carriage in position press the you have your media and carriage in position press the
 “Select” button, while in the Local Screen, to move the “Select” button, while in the Local Screen, to move the