Differences
This shows you the differences between two versions of the page.
Next revisionBoth sides next revision | |||
24_inch_vinyl_cutter [2018/04/04 12:27] – created admin | 24_inch_vinyl_cutter [2018/04/04 12:40] – admin | ||
---|---|---|---|
Line 1: | Line 1: | ||
Here are some common issues and resolutions that may help. | Here are some common issues and resolutions that may help. | ||
- | |||
- | Cutter running very slow. | ||
Line 15: | Line 13: | ||
| | | | ||
If you look at the LCD, the top of the readout is the speed in mm/s. If it is at 100, someone accidentally hit the down arrow and set the speed very slow. Ideal speed is 300 mm/s and 80 to 100 grams of pressure. | If you look at the LCD, the top of the readout is the speed in mm/s. If it is at 100, someone accidentally hit the down arrow and set the speed very slow. Ideal speed is 300 mm/s and 80 to 100 grams of pressure. | ||
+ | |- | ||
+ | | | ||
+ | The cutter performs erratically | ||
+ | during cuts, stops cutting | ||
+ | before the cut is finished, or | ||
+ | cuts lines that do not appear in | ||
+ | the design. | ||
+ | | | ||
+ | Some computers do not work well when connected via the USB port of the | ||
+ | cutters. If you are having problems while cutting and are using the USB cable | ||
+ | to connect from your cutter to computer, you may wish to try the serial cable | ||
+ | connection to avoid further problems. If a serial cable connection is not available | ||
+ | on your computer, you can try a third party USB to serial connector or a PCI card | ||
+ | serial adapter for your computer. | ||
+ | |- | ||
+ | | | ||
+ | After the first cut is made, | ||
+ | subsequent cuts are made over | ||
+ | the top of the original, or vinyl | ||
+ | is fed backwards until it loses | ||
+ | contact with the rollers. | ||
+ | | | ||
+ | After a cut is made, you will need to reset the origin of the cutter. If the origin is | ||
+ | not set again, the first origin will remain in the cutter and the cutter will return to | ||
+ | this position before making any further cuts. To reset the origin; from the main | ||
+ | screen of the cutter, press the Offline/ | ||
+ | button. | ||
+ | |- | ||
+ | | | ||
+ | Cuts are jagged or inconsistent. | ||
+ | | | ||
+ | The Blade may be dulled or damaged. Replace with a new blade and try again. | ||
+ | Make sure that the blade can turn freely (by attempting to turn it with your | ||
+ | fingers while the release button of the Blade Carriage is pressed). | ||
+ | Adjust the blade depth of the Blade Carriage (page 17) and Force setting on the | ||
+ | cutter (page 8) until you are getting solid, uniform cuts. Start with a blade depth | ||
+ | of around 1/64th of an inch and a pressure setting of 100g and try an increased | ||
+ | pressure setting before attempting to increase the blade depth. | ||
+ | |- | ||
+ | | | ||
+ | Issue | ||
+ | | | ||
+ | resolution | ||
+ | |- | ||
+ | | | ||
+ | Issue | ||
+ | | | ||
+ | resolution | ||
+ | |- | ||
+ | | | ||
+ | Issue not listed here | ||
+ | | | ||
+ | Sorry. | ||
|} | |} | ||