Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
policies:general_policies [2023/10/06 14:14] – Jeff Johnsonpolicies:general_policies [2025/03/05 22:03] (current) – [Consumables] Nathan Payne
Line 30: Line 30:
 There is a boneyard shelf in the hallway containing all kinds of free stuff. Items such as tape, glue, zip-ties, soldering equipment (i.e. flux, solder), hot-glue, and wiggle-eyes are also free and are in the card catalog. There is a boneyard shelf in the hallway containing all kinds of free stuff. Items such as tape, glue, zip-ties, soldering equipment (i.e. flux, solder), hot-glue, and wiggle-eyes are also free and are in the card catalog.
  
-Filament for the 3D printer costs $0.10 a gram. There is a scale next to the 3D printer to weigh your prints. You must pay for your plastic, even if your part is a disastrous failure! This fee helps pay for maintenance and plastic.+Filament for the 3D printer is sometimes available, coordinate with the Fab Lab area lead. 
  
 The laser cutter is free for non-commercial purposes, and $1 per minute for commercial purposes. More details can be found on the page for the Full Spectrum Laser. Scrap material for the laser is located underneath the table. The laser cutter is free for non-commercial purposes, and $1 per minute for commercial purposes. More details can be found on the page for the Full Spectrum Laser. Scrap material for the laser is located underneath the table.
  
-Scrap wood are in the woodshop and should be marked as such.  Any wood with a red or yellow dot is not available for your use.+Scrap wood are in the woodshop and should be marked as such.  
  
 Items in the boneyard are also free. Items in the boneyard are also free.