Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| equipment:full_spectrum_90_watt_laser_cutter [2020/09/21 21:08] – [Special Instructions] leamon | equipment:full_spectrum_90_watt_laser_cutter [2026/10/16 15:11] (current) – Fix broken links (reviewed by Tim 2026-10-16) — new-003 wiki master | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ====== Full Spectrum 90 watt 24" | ====== Full Spectrum 90 watt 24" | ||
| - | {{: | + | |
| This is one of the laser cutters we have at ChattLab. | This is one of the laser cutters we have at ChattLab. | ||
| Line 56: | Line 56: | ||
| - Rotate the power switch clockwise to turn the machine on. | - Rotate the power switch clockwise to turn the machine on. | ||
| - As the machine boots up, verify that it connects to the network. | - As the machine boots up, verify that it connects to the network. | ||
| - | * This particular machine is set up to connect with the IP address 192.168.121.19. | + | * This particular machine is set up to connect with the IP address 192.168.121.20. |
| * After the machine has booted up completely, the second field of the second line should read D19 (for the last number in the IP address). | * After the machine has booted up completely, the second field of the second line should read D19 (for the last number in the IP address). | ||
| * If the machine does not connect to the network, turn it off for 10 seconds, and turn it back on. It usually connects on the first try, but sometimes it might take a couple. | * If the machine does not connect to the network, turn it off for 10 seconds, and turn it back on. It usually connects on the first try, but sometimes it might take a couple. | ||
| Line 75: | Line 75: | ||
| ===== Details ===== | ===== Details ===== | ||
| - | {{: | + | |
| {| class=" | {| class=" | ||