Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
equipment:full_spectrum_90_watt_laser_cutter [2020/09/21 21:05] – [Safety] leamonequipment:full_spectrum_90_watt_laser_cutter [2020/11/30 19:55] (current) – Fix IP address jbrown
Line 19: Line 19:
  
   * **Do not run the laser at more than 85% power.**  Doing so significantly shortens the life of the laser tube (which is expensive).  Similarly, you wouldn't frequently red-line your car, running the engine at it's max RPM.  Likewise, please do not run the laser near its maximum range.  Keep it at or below 85% power.   * **Do not run the laser at more than 85% power.**  Doing so significantly shortens the life of the laser tube (which is expensive).  Similarly, you wouldn't frequently red-line your car, running the engine at it's max RPM.  Likewise, please do not run the laser near its maximum range.  Keep it at or below 85% power.
 +
 +**The following instructions are a work in progress, but should be finished soon (as of 2020-09-21).**
  
 === Design === === Design ===
Line 54: Line 56:
   - Rotate the power switch clockwise to turn the machine on.   - Rotate the power switch clockwise to turn the machine on.
   - As the machine boots up, verify that it connects to the network.   - As the machine boots up, verify that it connects to the network.
-      * This particular machine is set up to connect with the IP address 192.168.121.19.+      * This particular machine is set up to connect with the IP address 192.168.121.20.
       * After the machine has booted up completely, the second field of the second line should read D19 (for the last number in the IP address).       * After the machine has booted up completely, the second field of the second line should read D19 (for the last number in the IP address).
       * If the machine does not connect to the network, turn it off for 10 seconds, and turn it back on.  It usually connects on the first try, but sometimes it might take a couple.       * If the machine does not connect to the network, turn it off for 10 seconds, and turn it back on.  It usually connects on the first try, but sometimes it might take a couple.