Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionLast revisionBoth sides next revision | ||
equipment:full_spectrum_90_watt_laser_cutter [2020/09/21 21:03] – [Special Instructions] leamon | equipment:full_spectrum_90_watt_laser_cutter [2020/09/21 21:08] – [Special Instructions] leamon | ||
---|---|---|---|
Line 3: | Line 3: | ||
{{: | {{: | ||
- | We currently have two of these saws at ChattLab, both very similar to theother. | + | This is one of the laser cutters we have at ChattLab. |
- | Great for cutting and engraving many different types of flat surfaces. | + | Laser cutters are great for cutting and engraving many different types of flat surfaces, to very precise dimensions. |
The manual can be found [[https:// | The manual can be found [[https:// | ||
Line 13: | Line 13: | ||
* **Never cut vinyl plastic on the laser cutter!** | * **Never cut vinyl plastic on the laser cutter!** | ||
* Keep the lid shut on the laser cutter whenever it is operating. | * Keep the lid shut on the laser cutter whenever it is operating. | ||
- | * Remain with the laser cutter whenever it is in operation. | + | * Remain with the laser cutter whenever it is in operation. |
* Please make sure that the water cooler and exhaust/air assist are on before operating the laser cutter. | * Please make sure that the water cooler and exhaust/air assist are on before operating the laser cutter. | ||
Line 19: | Line 19: | ||
* **Do not run the laser at more than 85% power.** | * **Do not run the laser at more than 85% power.** | ||
+ | |||
+ | **The following instructions are a work in progress, but should be finished soon (as of 2020-09-21).** | ||
=== Design === | === Design === |