Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Next revision		Previous revision
equipment:craftsman_scrollsaw [2020/09/03 20:14] – created leamonequipment:craftsman_scrollsaw [2022/08/30 23:16] (current) – zane_luna
Line 1: Line 1:
-====== Craftsman scroll saw ====== +====== Craftsman Scroll Saw ======
  
 +{{ :equipment:scroll_saw.jpeg?400 |}}
  
 The scroll saw is good for cutting curves and fine features into wood, as well as doing interior cuts. The scroll saw is good for cutting curves and fine features into wood, as well as doing interior cuts.
Line 14: Line 14:
 ===== Special Instructions ===== ===== Special Instructions =====
  
-  * Start the saw. +  - If you need to do inside/interior cuts on your wood, you will need to feed the blade through a pre-drilled hole.  See instructions on changing the blade to figure out how to do this. 
-  * Feed your work into the saw in a controlled fashion.+  - Start the saw by pulling the speed adjustment knob out 
 +  - Feed your work into the saw in a controlled fashion.
       * If you find burn marks on your wood, you need to move the wood through the saw a bit more quickly, or reduce the saw speed.       * If you find burn marks on your wood, you need to move the wood through the saw a bit more quickly, or reduce the saw speed.
-  * Make sure the saw comes to a complete stop before walking away from it.+  - Stop the saw by pushing the speed adjustment knob in.  Make sure the saw comes to a complete stop before walking away from it.
  
 +=== Changing the blade ===
 +  - Remove the tension on the old blade using the knob on the top.
 +  - Loosen the screws holding the blade in place on both the top and the bottom (adjusted from the right hand side).  I used a 5/32" hex wrench, which worked but was a bit loose.  It probably takes a metric size if you can find them, maybe a 4mm?  (If you figure out which size, please add it to the wiki?)
 +  - Remove the old blade if you're replacing it.
 +  - Hook the blade pins into the bottom blade holder.  The teeth on the blade should point down, pushing the wood into/against the table when cutting (not lifting it up).  To access the bottom part, it helps to tilt the table to the side.
 +  - Holding the blade with the bottom pins still in place, hook the top pins in place.  It will probably help to adjust the tensioning knob to catch the top pins and hold the blade in place (but not too tight yet).
 +  - Tighten down the top and bottom screws holding the blade in place.
 +  - Adjust the tension knob.  You want the blade nice and tight.  It should give a nice "twang" when you pluck it.
 +  - Adjust the table back to square (or whichever angle you like), and check it with a tri or combination square if it's important to you.
 ===== Details ===== ===== Details =====
  
Line 45: Line 55:
 |120 Volt |120 Volt
 |- |-
-|Owners+|Owner
 |ChattLab |ChattLab
-|- 
-|Who to call? 
-|? 
 |- |-
 |} |}