Differences
This shows you the differences between two versions of the page.
Next revision | Previous revisionLast revisionBoth sides next revision | ||
equipment:craftsman_scrollsaw [2020/09/03 20:14] – created leamon | equipment:craftsman_scrollsaw [2020/09/08 20:47] – [Details] leamon | ||
---|---|---|---|
Line 14: | Line 14: | ||
===== Special Instructions ===== | ===== Special Instructions ===== | ||
- | | + | |
- | | + | - Start the saw by pulling the speed adjustment knob out |
+ | | ||
* If you find burn marks on your wood, you need to move the wood through the saw a bit more quickly, or reduce the saw speed. | * If you find burn marks on your wood, you need to move the wood through the saw a bit more quickly, or reduce the saw speed. | ||
- | | + | |
+ | === Changing the blade === | ||
+ | - Remove the tension on the old blade using the knob on the top. | ||
+ | - Loosen the screws holding the blade in place on both the top and the bottom (adjusted from the right hand side). | ||
+ | - Remove the old blade if you're replacing it. | ||
+ | - Hook the blade pins into the bottom blade holder. | ||
+ | - Holding the blade with the bottom pins still in place, hook the top pins in place. | ||
+ | - Tighten down the top and bottom screws holding the blade in place. | ||
+ | - Adjust the tension knob. You want the blade nice and tight. | ||
+ | - Adjust the table back to square (or whichever angle you like), and check it with a tri or combination square if it's important to you. | ||
===== Details ===== | ===== Details ===== | ||
Line 45: | Line 55: | ||
|120 Volt | |120 Volt | ||
|- | |- | ||
- | |Owners | + | |Owner |
|ChattLab | |ChattLab | ||
- | |- | ||
- | |Who to call? | ||
- | |? | ||
|- | |- | ||
|} | |} | ||