Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| 3dlab [2022/12/10 23:33] – Added links to 3DLab Accelerated Assessment bradley_madaris | 3dlab [2022/12/13 21:25] (current) – [DON'T] Resolved formatting issues. bradley_madaris | ||
|---|---|---|---|
| Line 35: | Line 35: | ||
| * DON'T leave materials or tools laying out, near or on the 3D printers. | * DON'T leave materials or tools laying out, near or on the 3D printers. | ||
| * //Such as filament spools inside the 3D printers, scraps from failed prints, support material.// | * //Such as filament spools inside the 3D printers, scraps from failed prints, support material.// | ||
| - | * DON'T attempt to modify or perform repairs on any equipment. Only the FabLab Area Lead, and those approved, are allowed to do so. | + | * DON'T attempt to modify or perform repairs on any equipment. |
| + | * //Only the FabLab Area Lead, and those approved, are allowed to do so.// | ||
| + | * DON'T use any tapes, adhesives, " | ||
| + | * //This practice is no longer required like it was in the early days of 3D printing. You should be able to print straight onto clean, flat glass without any adhesion issues. If there is problems with being able to do so, reach out to the FabLab Area Lead for more assistance.// | ||
| * DON'T use material that is brittle or water logged. | * DON'T use material that is brittle or water logged. | ||
| * //To test if material is brittle or water logged, bend a piece of the filament in half with your fingers. If it yields but does not break, you should be good to use it. If it snaps, do NOT use it. You must dry the material before use. This prevents unnecessary and avoidable clogged hot ends.// | * //To test if material is brittle or water logged, bend a piece of the filament in half with your fingers. If it yields but does not break, you should be good to use it. If it snaps, do NOT use it. You must dry the material before use. This prevents unnecessary and avoidable clogged hot ends.// | ||
| - | * DON'T use any material not approved for use. Any materials not approved must be documented, reviewed and approved for use by the FabLab Area Lead. | + | * DON'T use any material not approved for use. |
| + | * //Any materials not approved must be documented, reviewed and approved for use by the FabLab Area Lead.// | ||